Foredom set of 4 collets for No 8 handpiece, .8mm,1.6mm,2.35mm,3.18mm
Foredom table-top dial control for SR motor
Foredom bench clamp Clamps to any bench up to 2-1/4" thick and holds all motor hanger and handpiece holder rods.
Foredom drill press for flex shaft tool - Rugged and precise stand which converts your Foredom flexible shaft power tool into a drill press by securely holding a handpiece in...
Foredom handpiece holder for No 30 and No 44 handpieces
Foredom handpiece rest - slides onto motor hangers with 1/2" diameter or smaller rods.
Foredom hones - available from Coarse through to Extra Fine
Foredom maintenance kit for 1/6hp SR motor Kits includes inner shaft, pair of motor brushes, grease, and operation manual. Maintenance kits for flex shaft machines with key tip sharts (NOT...
Foredom MH-170 high speed rotary handpiece MH-170 High Speed Rotary Handpiece has a contoured grip for precise and very high speed work up to 38,000 rpm. It has a fan...
Foredom Micro Motor 50000rpm with MH-150 high speed brushless handpiece K.1050 Dual Port Kit comes with One Handpiece: • Brushless rotary handpiece connects to port in the back of the control...
*Prices exclude GST High torque and speed up to 50,000rpm. 230V. Kit includes control box with digital display,an ergonomic handpiece with 2.34mm collet installed, variable speed foot pedal, handpiece cradle,...
Foredom Micro Motor 38000rpm with MH-170 high speed rotary handpiece For high speed applications up to 38,000 rpm including light deburring of cast pieces, bright cutting in jewelry making and...
Foredom Motor brushes for MH-170 high speed rotary handpiece (pair)
Foredom No 15 hammer handpiece for stone setting The H.15 Handpiece has hammering rather than rotary action for use at low speed (0-5,000 rpm) by jewelers for stone setting and decorative...
Foredom No 20 handpiece quick release 2.34mm collet The H.20 is for use ONLY with 3/32″ (2.35mm) shank burs. A lever action on the the handpiece body is all that...
Foredom No 30 handpiece with 3 jaw chuck (up to 4mm) This general purpose handpiece has prelubricated ball bearings that do NOT require any additional lubrication.
The H.44T is a collet type handpiece that accepts accessories with up to 6mm diameter shanks. Has prelubricated ball bearings that require no additional lubrication. Comes with 2.34mm, 3mm, 6.00mm...
Foredom No 8 handpiece with 2.35mm and 3.18mm collets This handpiece is a slim collet type handpiece with pre-lubricated ball bearings that require no additional lubrication. It has a chuck...
Foredom spring safety clip This small spring clip performs an important safety function. It helps to prevent jumping and twisting of a Foredom motor during start-up and acceleration. The clip...
Foredom SR Motor 1/6hp 18000rpm with flex shaft No 30 handpiece features a geared 3-jaw chuck that accepts any size shank or drill bit up to 5/32"
Foredom SR Motor 1/6hp 18000rpm with flex shaft No 44T handpiece with 3 collets in 2.34mm, 3mm, 6mm